Quote:

Hey Preston,

It is only a problem where I show the floor...and there it is really a serious issue. This poor guy had just been to the groomers in the last week, too. I am not at the computer where I keep the stuff, or I would post some samples...but they really are a pain in the hind-most-end.

James




I was just asking because I treat small problems differently than bigger problems. Wasn't sure which we were talking about with your originals.

In any case, if it is white hair on black, if you haven't tried it...pull up an original, switch to LAB mode, highlight the Luminosity channel, and then go from there with your normal kind of fixes. Switch back to RGB to inspect results.